Page 1 of 1

Pennants for Sale

PostPosted: Mon Nov 25, 2013 9:56 am
by peedee
The pennants have arrived and are ready for distribution. Many have been following this project. If you are interested in purchasing them then PM me to arrange a sale.
You can review previous posts to see the available red, blue, black and white colors. I also had some blanks made in white plastic. Keep in mind these were patterned off the 1969 Evinrude boats and will fit that year. I am assuming it will fit the other years and the customers will verify this. I am hoping they will. I also suspect they could be used on some of the vintage outboard motor cases that I have seen. They will fit snowmobiles but the pins on the snowmobile version are different in size but not position. The pins are fore to aft 2 3/4 " and top to bottom APPROX. 1 3/16".
I have also procured from the original manufacturer the bright red cap plugs that screw into the exhaust housing for that vintage stern drive (OMC # 313221). Finally we have the rubber gas tank vent tube grommet that seals the vent line at the transom (OMC # 906318). The grommets are whole but I think were split by OMC.
I do not have the mounting hardware which includes a black rubber washer and a spring clip. Hopefully you can reuse existing hardware. I suggest a small pair of long nose vise grip pliers with flat tips to gently remove the clips. You can get them at the local hardware store. Thank you for your patience. Tom

Prices:
Emblems $2.50 per emblem
Red Cap plugs $1.00 each
Black Rubber Grommets $1.00 each
Shipping and Handling $5.00

Re: Pennants for Sale

PostPosted: Tue Nov 26, 2013 1:51 pm
by peedee
Will try and work on that tonight. Tom

Re: Pennants for Sale

PostPosted: Thu Nov 28, 2013 3:48 pm
by peedee
Photos of pennants, plug to stern drive, and grommet in transom.

Re: Pennants for Sale

PostPosted: Thu Nov 28, 2013 5:12 pm
by peedee
Some more photos. Tom

Re: Pennants for Sale

PostPosted: Sat Dec 07, 2013 10:02 am
by peedee
A photo showing pin spacing. All pennants are the same size. There is no port or starboard configuration. Pins on one side face forward and on the other side they face rearward. On the dash they face port. Tom